Jonsered CS 2153 Manual Pagina 35
- Pagina / 44
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
English – 35
MAINTENANCE
”Air Injection” centrifugal cleaning
Centrifugal cleaning means the following: All air to the
carburetor passes through the starter. Dirt and dust is pushed
out by the cooling fan.
IMPORTANT! In order to maintain operation of the centrifugal
cleaning system it must be regularly maintained. Clean the air
intake to the starter, the fins on the flywheel, the space around
the flywheel, inlet pipe and carburetor compartment.
Winter use
Running problems can occur when using the machine in the
cold and snowy conditions caused by:
• Too low engine temperature.
• Icing of the air filter and carburetor.
Special measures are therefore often required:
• Partly mask the air inlet on the starter to increase the
working temperature of the engine.
• Preheat the intake air to the carburetor by using the heat
from the cylinder.
Temperature 0°°
°°
C (32°°
°°
F) or colder:
The cylinder cover is designed so it can be adjusted for
running in cold weather. Twist the winter flap so that
preheated air from the cylinder can pass into the carburetor
space preventing icing of the air filter, etc.
For temperatures below -5°C (23°F) and/or in snow
conditions there is also:
• a special cover (A) for the starter housing
• a winter plug (B) for the air nozzle that is fitted as shown.
These reduce the flow of cooling air and prevent large
amounts of snow from being sucked into the carburetor
space.
CAUTION! When the winter plug is fitted the winter flap must
be open!
Heated handles
(CS 2152W, CS 2153W)
On models with the model code W, both the front handle bar
and the rear handle are equipped with electrical heating coils.
These are supplied with electricity from a generator built into
the chain saw.
When the switch is pushed downwards, the heat is switched
on. When the switch is pushed upwards, the heat is switched
off.
Electrical carburetor heating
(CS 2152WH, CS 2153WH)
On models with the designation CARBURETOR HEATING
there is an electrically heated carburetor. Electrically powered
heating prevents ice formation in the carburetor. A thermostat
regulates the heating so that the carburetor always has the
right working temperature.
IMPORTANT! If the temperature rises above -5°C (23°F) or
0°C (32°F) respectively the machine MUST be restored to
its normal set-up. Otherwise there is a risk of overheating,
which can cause severe engine damage.
H
H
- CS 2152 CS 2153 1
- CONTENTS 3
- ODUCTION 4
- GENERAL SAFETY PRECA 6
- GENERAL SAFETY PRECAUTIONS 10
- ASSEMBLY 16
- FUEL HANDLING 17
- STARTING AND STOPPING 19
- WORKING TECHNIQUES 21
- MAINTENANCE 29
- TECHNICAL DATA 37
- YOUR WARRANTY RIGHTS AND 39
- OBLIGATIONS 39
- Kickback safety precautions 40
- Other safety precautions 40
- ´®z+RI•¶55¨ 42
Relacionado con productos y manuales para Motosierras Eléctricas Jonsered CS 2153
(15 paginas)Denver DVH-1241 manuály
Uživatelské manuály a uživatelské příručky pro DVD přehrávače Denver DVH-1241.
Poskytujeme 1 manuály pdf Denver DVH-1241 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comentarios a estos manuales